Das-audio Action Series Manuel d'utilisateur télécharger pdf (Page 15)

The Allen-head screws must be removed and

replaced by M10 eyebolts on one side of the

enclosure. Each rigging point has 200 kg (440 lb)

working load limit. Then choose the slings or

chains of required load resistance and length,

bearing in mind that the length difference between

the front and back slings or chains will determine

the vertical orientation. Alternatively, the back

bottom eyebolt points can be used to provide

vertical orientation.

The ANL-2 set is an optional set of three

eyebolts and three carabiners. (Dimensions are in

milimetres).

Flying with eyebolts

Each ANL-2 eyebolt has a rated working load

of 200 kg. (440 lb). Each ANL-2 carabiner has a

working load of 330 kg (726 lb). If using other

hardware, make sure it is rated to handle the

required load.

When using eyebolts it is important to bear in

mind that the rated working load is only true for a

load applied in the plane of the eye, and is

significantly reduced for other angles. The drawing

illustrates the concept. The table shows the

variation of the working load as a function of the

load angle. In the case of the ANL-2 eyebolt, this

means that the 200 kg working load becomes 60

kg at 45 degrees. Do not use eyebolt flying if the

load angle is higher than 45 degrees.

The following illustrations show different views

on eyebolt flying for a single box. The length of the

back cables or chains determines the vertical

angle of the box.

ANL-2

Manual del Usuario / action passive series / User’s Manual

100% 65% 30% 25%

0 Degrees

% Working

load

30 Degrees 45 Degrees More than 45

Degrees

1 2 ... 10 11 12 13 14 15 16 17 18 19

Pas de commentaire

Das-audio Action Series Manuel d'utilisateur Page 15