Das-audio DASnet V1.5 Manuel d'utilisateur télécharger pdf (Page 34)

Preset changes are bidirectional so if a preset is changed on the software it will be also changed

on the cabinet. And vice versa, a change on the cabinet will be shown as well on the software.

IMPORTANT: all DASnet control parameters (gain, delay, presets, mute, solo...etc) are stored on

the micro controller included in the amplifier. This means that after switching off the system all values

of the parameters will remain the same in memory for the next time the system is switched on.

IMPORTANT: when the user is not sure about the internal settings in the micro controller (delay,

gain etc) the best thing is to do a factory settings reset. Factory settings puts all the parameters

at zero. Device name will remain the same (in this case aero 40A-15).

Factory settings reset can be done via software: (check that gain and delay are set up at zero)

IMPORTANT: The default or factory settings on the aero 40A are:

Number of Units: 1 Unit

Throw: Mid Throw

Highpass filter: OFF

Physically if the user wants to do a reset or factory settings, the control joystick and the display

has to be used:

default factory

settings

Press OK for 2 seconds

By clicking right button select menu

number 2 - utilities

When Restore menu is active

press and hold for 2 seconds

DASnet - 34

1 2 ... 29 30 31 32 33 34 35 36 37 38 39 ... 69 70

Pas de commentaire

Das-audio DASnet V1.5 Manuel d'utilisateur Page 34